|
|
|
![]() |
|
|||||||
|
||||||||
![]() |
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
#1
|
||||
|
||||
|
Re: pic: Bit Buckets 2015 Prototype Drive Pod
Neat drive module. I like the single reduction, very simple. What sort of fasteners are you using to tie everything together?
Quote:
Quote:
http://i.imgur.com/QCryxlE.jpg https://www.youtube.com/watch?v=2HHVwJ_C31M The side-panels took less than 2 min each to cut from 0.032 5052 Al. http://i.imgur.com/gU6AhRa.jpg Or a 4'x4' CNC router? All of these parts together took about 17min of cut time, most of which was in the pocketing. http://i.imgur.com/FgtZxiL.jpg Last edited by JamesCH95 : 15-01-2015 at 09:40. |
|
#2
|
||||
|
||||
|
Re: pic: Bit Buckets 2015 Prototype Drive Pod
Exactly what wood are you burning with your laser. I say exactly because I have access to a 160 watt laser and have tried cutting 1/4 Baltic birch and if it will cut depends on where I get it.
Some cuts real nice and some will only seem to cut to the glue line then just starts burning. So, if you have any details on what you are using it would be appreciated. Thanks |
|
#3
|
|||
|
|||
|
Re: pic: Bit Buckets 2015 Prototype Drive Pod
Quote:
|
|
#4
|
||||
|
||||
|
Re: pic: Bit Buckets 2015 Prototype Drive Pod
Yes it will cut an inch of pine but not some plywoods.
|
![]() |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|