Vex Solenoid Base Mount Configuration

[zcohen]

Check out this link:
http://content.vexrobotics.com/vexpr...s-20141010.PDF
You can see on the side of the mounts you have exhaust ports--just let these be, and a pressure input in the middle. You have you incoming air from your tanks go to this port. You then attach the solenoids along the top, as shown on the second page. The coresponding ports on the side are where you hook up the air to go out as the solenoid is activated. If you have a spare port open, you need to cover it using the blank station kit or else it will leak out of that hole.