|
|
|
 Let's see. There's the Dean of Students, the Dean of Admissions, The Dean of Engineering, and the Dean of Kamen? Sometimes known as the Denim Dean. - Bill_B [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| Let's see. There's the Dean of Students, the Dean of Admissions, The Dean of Engineering, and the Dean of Kamen? Sometimes known as the Denim Dean. - Bill_B [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#2
18-01-2015, 01:46
|
||||
|
||||
|
Re: pic: S'no problem
Clever use of your resources. Machining delrin to a nice finish is tricky, but it can be done. Is that why you are sanding, to get a better finish?
If so, then guiding the inevitably long/ stringy chip away from the cutter to prevent it from wrapping works well. No need to move to sanding. Remember to remove the water from the lathe! 
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Threaded Mode