3d printed talon mounts

[dellagd]

Why not make it double sided for the ability to mount 4 at once? I don't think it would be too difficult to make the design such that it can be structurally sound but also accommodate talons on each side.

[audietron]

Originally Posted by dellagd

Why not make it double sided for the ability to mount 4 at once? I don't think it would be too difficult to make the design such that it can be structurally sound but also accommodate talons on each side.

The diagonal of the screw holes makes it so they can not be mirrored in this way, although if one talon is turned 90 degrees the holes are separated far enough for them to be mounted front and back.

[kevin.li.rit]

You could if you bought a heat set threaded insert to allow mounting without the needed of a nut.

[Jon Stratis]

Originally Posted by audietron

The diagonal of the screw holes makes it so they can not be mirrored in this way, although if one talon is turned 90 degrees the holes are separated far enough for them to be mounted front and back.

Make it a little thicker and include recessed hex holes for the nuts - stick a nut in there and bolt away from both sides, the recess holds the nut from turning.