Anderson PowerPole for CAN bus?

Add a little more grease if you aren't sure exactly how much you need. - MrForbes [more]

		Chief Delphi > Technical > Electrical
Anderson PowerPole for CAN bus?

Thread Tools

Rating:

Display Modes

#20

19-01-2015, 08:20

Al Skierkiewicz Al Skierkiewicz is offline

Broadcast Eng/Chief Robot Inspector

AKA: Big Al WFFA 2005

FRC #0111 (WildStang)

Team Role: Engineer

Join Date: Jun 2001

Rookie Year: 1996

Location: Wheeling, IL

Posts: 10,772

Al Skierkiewicz has a reputation beyond repute

Re: Anderson PowerPole for CAN bus?

I would not use wire nuts.
If you have access to DB-9 hardware, that is not a bad way to go either. Easy to terminate, crimp or solder, with standard hardware everywhere, including IDC (ribbon cable) termination.

__________________
Good Luck All. Learn something new, everyday!
Al
WB9UVJ
www.wildstang.org
________________________
Storming the Tower since 1996.

« Previous Thread | Portal | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode	Rate This Thread:

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts vB code is On Smilies are On [IMG] code is On HTML code is Off

Forum Jump

All times are GMT -5. The time now is 23:58.

The Chief Delphi Forums are sponsored by Innovation First International, Inc.