Anyone heard more about the Ekocycle 3D printer?

You Texas boys and your fancy swerve drive. Why don't ya'll come up here to New England? I'm about to saddle me up a skid steer and herd ya'll fellers into a corner. - Tom Bottiglieri [more]

		Chief Delphi > FIRST > General Forum
Anyone heard more about the Ekocycle 3D printer?

Thread Tools

Rating:

Display Modes

#13

20-01-2015, 17:14

rockychat3 rockychat3 is offline

Registered User

FRC #4859

Join Date: Dec 2014

Location: Byron, MN

Posts: 5

rockychat3 is an unknown quantity at this point

Re: Anyone heard more about the Ekocycle 3D printer?

Is it possible to use any PET as long as you load it into their special cartridges? The printer is super cool but I'm terrified to use up the included spools at $50/each!

Example: http://www.amazon.com/MadeSolid-PET-.../dp/B00PH4D5P6

« Previous Thread | Portal | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode	Rate This Thread:

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts vB code is On Smilies are On [IMG] code is On HTML code is Off

Forum Jump

All times are GMT -5. The time now is 15:50.

The Chief Delphi Forums are sponsored by Innovation First International, Inc.