|
|
|
 Pro: Very easy to build with. Con: HEAVY AS ELEPHANTS - Tetraman [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| Pro: Very easy to build with. Con: HEAVY AS ELEPHANTS - Tetraman [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#3
23-01-2015, 01:38
|
||||
|
||||
|
Re: Retaining Rings use on chassis
You will specifically want an E-Clip (slide in side mount). Harbor Freight has an assortment box cheap if that's near by, otherwise look at Mc Master Carr. The standard .5 shaft E clip is 0.046 wide by 0.396 ID diameter. That's a lot of Turning on some pretty hard 7075.
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Threaded Mode