|
|
|
![]() |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#3
|
||||
|
||||
|
Re: Ekocycle Issues
That happens on our Replicator 2 as well at fills over 70% or so. I don't know much about the Ekocycle but are you able to adjust fill on it? Unless this is an integral part you don't need 100% fill.
If not, a direct option would be to heat the plate because the piece is cooling down too fast and warps. |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|