|
|
|
![]() |
|
|||||||
|
||||||||
|
|
Thread Tools |
Rating:
|
Display Modes |
|
#10
|
||||
|
||||
|
Re: Photoeye's not working-Difference between RoboRIO and Digital Side Card?
Did some more extensive testing tonight during our meeting.
The Working AB Part number was 42CA-P2MNB-A2 Another non-functioning Banner sensor was QS30LV We also found the following Banner Switches to also work. T18SN6FF50 T30SN6FF400 I tested with the sensors connected to the both the 12v 2a power rail, and also wired direct to the same power leads as the roboRIO without any impact on working state. Both non-working Banner part numbers status lights work as expected, and I tested multiple sensors of each type, Power indicator works, and sensor tripped worked, just would not fire the roborio input. Last edited by tr6scott : 27-01-2015 at 08:33. Reason: Took out dash in AB part number. |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|