|
|
|
 I'm not worried about talking to the robot, but I am worried about when the robot starts talking back... - Moros [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools |
Rating: 
|
Display Modes |
|
|
|
| I'm not worried about talking to the robot, but I am worried about when the robot starts talking back... - Moros [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools |
Rating:
|
Display Modes |
|
#7
27-01-2015, 21:52
|
||||
|
||||
|
Re: Vertical Tracks for Forklift
On the outside, we have 2" x 1" .125" wall rectangular aluminum tubing with some lightening pockets. The carriage has 8mm ID 22mm OD shielded bearings that roll on the 2" x 1". Our preliminary testing showed that delrin rollers didn't roll very nicely when loaded with 50 lbs cantilevered out a foot from the lift tower when the vertical distance between bearings was around 5", but ball bearings ran much more smoothly.
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Threaded Mode