|
|
|
 If my shop was snowed in and my unfinished robot was sitting in there, I'd dig it out with a plastic spoon or melt it out with a Bic lighter if I had to. Every hour counts. If there's a will, there's a way to make it happen. - sanddrag [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools |
Rating: 
|
Display Modes |
|
#1
|
|||
|
|||
|
Load and Friction
Hello!
we're planning on using a vexpro double sprocket 1/2id round for pulling our lift(about 80lbs max load), can I just make it an idle sprocket with the vexpro tube stock+1/4 bolt, or do I need some bearings for the friction? Paul |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Threaded Mode