|
|
|
 Teams that are consistently designing and end up with weight problems need to look at their design process and make corrections in "Weight Management". - Mike Martus [more] |
 |
|
|||||||
|
||||||||
 |
| Thread Tools | Rate Thread | Display Modes |
|
|
|
| Teams that are consistently designing and end up with weight problems need to look at their design process and make corrections in "Weight Management". - Mike Martus [more] |
|
|
|||||||
|
||||||||
|
| Thread Tools | Rate Thread | Display Modes |
|
#1
|
||||
|
||||
|
Talon SRX Connectors
What connectors (if any) are people using to connect Talon SRXs' CAN wires? We considered soldering and using latching Hansen Hobbies connectors. We ended up going with the latching connectors but out of curiosity, what did other teams go with? I have seen this brought up in a few other threads, but I haven't seen any threads with more than 1 or 2 post about it.
|
|
#2
30-01-2015, 12:40
|
|||||
|
|||||
|
Re: Talon SRX Connectors
This thread should have what you are looking for.
|
|
#3
30-01-2015, 15:17
|
||||
|
||||
|
Re: Talon SRX Connectors
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Linear Mode
