|
|
|
 This is a benefit of the district model. It brings the events back into the schools. - ezygmont708 [more] |
 |
|
|||||||
|
||||||||
 |
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| This is a benefit of the district model. It brings the events back into the schools. - ezygmont708 [more] |
|
|
|||||||
|
||||||||
|
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
#2
30-01-2015, 23:21
|
||||
|
||||
|
Re: Motor Controller issue
You are going to have to tell us what you expected to be the result of this. What PWM/CAN signal were you sending it, or were you sending it any PWM/CAN?
|
|
#3
31-01-2015, 11:07
|
||||
|
||||
|
Re: Motor Controller issue
We were expecting a full forward (that should be 12V), we did select the correct motor controller for each test in our code
The LED was blinking so our PWM wasn't full, even though the code was telling it to be full, we will try calibrating then get back to you Last edited by FRC2501 : 31-01-2015 at 11:18. |
|
#4
04-02-2015, 09:30
|
||||
|
||||
|
Re: Motor Controller issue
We calibrated all of our Talon SRs and now they give a full 12.55V output, we haven't tried a Jag yet but we only plan on using Talon SRs on our robot
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Hybrid Mode
