|
|
|
 if your robot weighs 1-1/2 tons, you have bigger problems then the legality of that jack... - ekapalka [more] |
 |
|
|||||||
|
||||||||
 |
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| if your robot weighs 1-1/2 tons, you have bigger problems then the legality of that jack... - ekapalka [more] |
|
|
|||||||
|
||||||||
|
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
#1
|
||||
|
||||
|
Re: Motor Controller issue
We were expecting a full forward (that should be 12V), we did select the correct motor controller for each test in our code
The LED was blinking so our PWM wasn't full, even though the code was telling it to be full, we will try calibrating then get back to you Last edited by FRC2501 : 31-01-2015 at 11:18. |
|
#2
04-02-2015, 09:30
|
||||
|
||||
|
Re: Motor Controller issue
We calibrated all of our Talon SRs and now they give a full 12.55V output, we haven't tried a Jag yet but we only plan on using Talon SRs on our robot
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Hybrid Mode
