Devantech SRF08 device adress issue?

[Richard100]

What language are you using? Which I2C bus (On-Board or MXP)? If LabVIEW, try running the I2C ENUM vi, which will discover all the devices by address on the bus. This way you can confirm that you're using the correct address (which is usually specified in hex), and that it's wired correctly.

[TylerStaudigel]

Originally Posted by Richard100

What language are you using? Which I2C bus (On-Board or MXP)? If LabVIEW, try running the I2C ENUM vi, which will discover all the devices by address on the bus. This way you can confirm that you're using the correct address (which is usually specified in hex), and that it's wired correctly.

I am using labview and the daventech is plugged into the i2c port in the roborio. I'll try and run the vi you suggest Monday when I can get back to the lab. I noticed that on the device data sheet the sensor was listed as having a hex address but when you call it out in labview it Eames a device number (ex dev0). What's up with that?

[Richard100]

Sounds like you're wired to the roboRIO On-Board I2C bus (there's another one within the MXP).

It's sounding like you haven't set the sensor address. The example Front Panel "Device Address" selections (Dev0 - Dev15) correspond to I2C address values. You can view these assignments by opening the Device Address Type Def (right click menu), then selecting Edit Items (right click menu again, from the Type Def's control). One of those values, when expressed in Hexadecimal format, corresponds to your sensor (hopefully).

I'm not familiar with this sensor, but judging from the code design it seems that it is a device that has selectable hex I2C addresses (guessing).

Easiest way might be to run the example at each setting on Device Address.