|
Wiring AXIS M1013 to 2015 system
I have a question regarding wiring the Axis M1013 network camera to the 2015 control system. The camera is rated for 5V@1.5A. The camera will run fine with 5V@2A, which the Voltage Regulator Module supplies. However, the VRM's 5V@2A terminals are reserved for the Wireless Bridge, as stated in R32:
"The Wireless Bridge power must be supplied by the 5V 2A (“Radio”) output of a Cross the Road Electronics Voltage Regulator
Module (VRM) (P/N: am-2857, 217-4245) and must be the only load connected to those terminals."
If the Wireless Bridge is the only load allowed on those terminals, where do we plug in the Axis Camera for power?
|
...isn't that part of the point? For high schoolers to do things they "could not have" by themselves? - AdamHeard [more] 
Threaded Mode