|
|
|
 we used to walk barefoot through five feet of snow to get to school, uphill both ways, with just barbed wire for mittens, and we liked it! - dlavery [more] |
 |
|
|||||||
|
||||||||
 |
| Thread Tools | Rate Thread | Display Modes |
|
|
|
| we used to walk barefoot through five feet of snow to get to school, uphill both ways, with just barbed wire for mittens, and we liked it! - dlavery [more] |
|
|
|||||||
|
||||||||
|
| Thread Tools | Rate Thread | Display Modes |
|
#1
|
|||
|
|||
|
Programming issue: encoder on articulated arm
My encoder is on an articulated arm. I want the arm to go to a desired position in teleop mode with one push of a button. The program works great when run directly through Labview with the Samantha WiFi. However when I try to run it on the FCS it bypasses my encoder portion of the program. Thank you for any help!
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Linear Mode
