Limit Swtich Help

[mmaunu]

Originally Posted by curtis0gj

The issue is when I press button 1 one relay goes in reverse and the other goes to kOn (LED BLANK) and when I press button 4 it goes in kForward(GREEN). Also the spike is stuck in kForward because it's always green unlike the other which is yellow.

I'm trying to figure out exactly what the behavior is that you are describing. I think it would help to use the two variable names like spike1 and spike2.

When you press button 1, spike1 goes in reverse and spike2 goes to kOn?

When you press button 4, which spike goes to kForward: spike1 or spike2? What does the other do?

Whichever goes to kForward, are you saying that it is now stuck in the kForward state no matter which buttons you push?

When you say yellow, is that possibly orange? The manual says that the possible colors are red, green, and orange. Do you see all three of those colors and a yellow?

In addition to checking the orientation of the PWM cable, check the power leads (both into the spikes and then out of the spikes) so that you are correctly getting power to power and ground to ground.