Compressor

[Mark McLeod]

The enums in Teleop are incorrect for Relay. That's why they have red dots.
Get a correct Relay Enum by

• Deleting the wire into Relay (the one with the red dot)
• Right-click on the now vacant Relay input node and choose Create->Constant

That's the correct Relay enum type.

• Now make copies of the correct one and replace all the others
• Finally, remove the Enum you created into Relay and wire Relay into the Select as it was before.
• If done correctly all the red dots should be gone.

Separately, is the status light on the Pneumatics Control Module blinking green?