|
|
|
![]() |
|
|||||||
|
||||||||
![]() |
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
#1
|
|||||
|
|||||
|
Re: pic: Team 701's Custom #25 Chain Clamps
We didn't have any, so making these plates was a quicker option. Plus, these plates play into how we tension our elevator chain. We are satisfied with their performance, and plan to keep them for our final design.
Last edited by bEdhEd : 07-02-2015 at 21:58. |
|
#2
|
||||
|
||||
|
Re: pic: Team 701's Custom #25 Chain Clamps
Looks good! A very neat solution. Did you use a CNC to make those or just a manual mill?
|
|
#3
|
|||||
|
|||||
|
Re: pic: Team 701's Custom #25 Chain Clamps
CNC. I'm sure a team with a manual mill can accomplish this with a small enough end mill.
|
![]() |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|