No compressor light on PCM, no compressor power, no CAN recognition of compressor

If you squeeze cost out hard enough, any component can become a failure point. - EricVanWyk [more]

		Chief Delphi > Technical > Pneumatics
No compressor light on PCM, no compressor power, no CAN recognition of compressor

Thread Tools

Rate Thread

Display Modes

08-02-2015, 21:58

adampaskowitz adampaskowitz is offline

Registered User

FRC #4345

Join Date: Dec 2011

Location: Los Angeles

Posts: 11

adampaskowitz is an unknown quantity at this point

Re: No compressor light on PCM, no compressor power, no CAN recognition of compressor

You're right. Thanks. I'll switch it back, but I honestly didn't notice any difference between the way the robot responded when wired with either of those two arrangements.

« Previous Thread | Portal | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode	Rate This Thread:

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts vB code is On Smilies are On [IMG] code is On HTML code is Off

Forum Jump

All times are GMT -5. The time now is 12:18.

The Chief Delphi Forums are sponsored by Innovation First International, Inc.