Need help reducing shaft diameter

Might change next year. Read the manual then too. - Billfred [more]

		Chief Delphi > FIRST > General Forum
Need help reducing shaft diameter

Thread Tools

Rating:

Display Modes

10-02-2015, 16:35

bEdhEd

Design and Drive Team Mentor

AKA: Frank E.G. Shiner

FRC #0701 (The RoboVikes)

Team Role: Mentor

Join Date: Nov 2012

Rookie Year: 2009

Location: Fairfield, CA USA

Posts: 488

Re: Need help reducing shaft diameter

Are you saying that you guys were trying to turn down the whole shaft as it is COTS, or did you cut it into smaller lengths for their specific use on the robot, then turn them down? Does the shaft have to be that long because it's part of your design?

__________________

« Previous Thread | Portal | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode	Rate This Thread:

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts vB code is On Smilies are On [IMG] code is On HTML code is Off

Forum Jump

All times are GMT -5. The time now is 20:54.

The Chief Delphi Forums are sponsored by Innovation First International, Inc.