Good day, Team 5526 greets you and needs your help:
We're using an elevator system for out robot this year however we need to program two
limit switches, one on top and one at the bottom of the elevator range in case the driver exceeds too much and prevent the elevator's pulley from breaking. The pulley moves with a motor attached, however I just want the top
limit switch to stop it from moving up, and the lower
limit switch to stop it from moving down. I don't want it to just shut down the machine. We're rookies, even though we do have fair knowledge about LabView, we have no clue how to program
Limit Switches.
Help would be highly appreciated.
It is hard to write code that conforms to a standard that isn't published... - AustinSchuh [more] 
Threaded Mode