|
|
|
 i feel lost without build season...like i should be somewhere working on something instead of sitting in my basement on my computer... - Wildcat [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| i feel lost without build season...like i should be somewhere working on something instead of sitting in my basement on my computer... - Wildcat [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#1
|
||||
|
||||
|
Broaching a bevel gear
We are planning an off season design project. It involves using a Bevel box ( http://www.andymark.com/product-p/am-2622.htm ) Unfortunately we need to use 1/2" Hex shafts as both shafts, and this gear box uses 3/8". (There use to be a 1/2 Hex version at Andymark, but it has been discontinued.)
My question is if it would be possible to broach these to 1/2 hex. Or alternatively, find a source for gears that would work with out broaching. 
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Threaded Mode