|
|
|
 "The safety log is the log people sit on to think about the unsafe act they've just committed." - Kevin Sevcik [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools |
Rating: 
|
Display Modes |
|
|
|
| "The safety log is the log people sit on to think about the unsafe act they've just committed." - Kevin Sevcik [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools |
Rating:
|
Display Modes |
|
#4
11-02-2015, 20:19
|
||||
|
||||
|
Re: General EKOCYCLE 3D Printer Thread
We have two problems.
1. It wontauto level and I have cycled through it 10 times finaly I just gave up with leveling it. 2. Now it wont feed the materal. It goes through the print process but its like the nozel is jamed. It looks clean but nothign will come out. Cant figure out how to purge it, clean it or even take the current roll of material out of the print nozel. 
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Threaded Mode