|
|
|
 Best way to get the word out for FIRST is Demo, Demo, Demo. There's no reason anyone in your community shouldn't know what you folks are doing. - Martinez [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| Best way to get the word out for FIRST is Demo, Demo, Demo. There's no reason anyone in your community shouldn't know what you folks are doing. - Martinez [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#1
|
|||
|
|||
|
PWM output not working?
Just got into the programming a few days ago. Suffice to say I'm trying to get the drive system working. For some reason when I run any of the examples, the PWM output doesn't work at all. I'm not sure what to look for and getting a little desperate!!
I've verified that the hardware setup is correct. Jumping signal wire to 6V gets the motor going so I know that that's working. I've hooked up the PWM signal to an oscilloscope as well. My setup is a single motor attached to a Victor 884 with input coming from PWM 0 on the RoboRIO. Joystick is also attached. 
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Threaded Mode