CAN Talon Does Not Move in Speed Mode

[Alan Anderson]

Section 17.5 of the TALON SRX Software Reference Manual lists the throttle range as -1023 to +1023. A throttle of -19 is very, very small--less than 2%. You might need to increase the P value.

Note that the speed value is in encoder counts per 100 milliseconds. You will need to convert from RPM (or whatever speed units you use) based on the number of encoder counts per revolution. Note also that the encoder is always read in 4x mode, so a 250 cycle per revolution encoder is actually 1000 counts per revolution.

[restouffer]

Thanks for the quick reply. We have increased the P value and will give it a try as soon as the fabrication team gets done with the robot.

[restouffer]

Yep, that was our problem. I'm not used to working with numbers in the thousands, and we were a bit worried about setting the value too high. Now we know better.

Thanks for your time.

[ozrien]

Glad you guys are up and running.

Just a guess : AppliedThrottle at -19 and ClosedLoopErr is -200, so I'm guessing Pgain was 0.1.

[restouffer]

Good guess. Changing P to 1 and speed to 400 seems to work much better.