|
|
|
 What about marriages ended by FIRST. I know that by Presidents Day my wife is not real happy with me :) - IndySam [more] |
 |
|
|||||||
|
||||||||
 |
| Thread Tools | Rate Thread | Display Modes |
|
|
|
| What about marriages ended by FIRST. I know that by Presidents Day my wife is not real happy with me :) - IndySam [more] |
|
|
|||||||
|
||||||||
|
| Thread Tools | Rate Thread | Display Modes |
|
#1
|
||||||
|
||||||
drill motors
what is the rpm of the drill motors in low gear/high gears exactly through the drill gearing?
|
|
#2
15-01-2002, 18:26
|
|||||
|
|||||
|
In the back of your "Zone Zeal" rule book there is a page that shows the ratings of all the motors.
Wayne Doenges |
|
#3
15-01-2002, 20:30
|
|||
|
|||
|
Hmmmm....
The drill motors run at 20023 RPMs idle. The high gear is 20:1 and the low gear is 60:1. So it should run at 1000 and 300 RPMs respectively. However, this is impossible because it would not free spin with the gearbox on. But you need to check the RPM to Torque chart to see the speed output at the torque output you want. |
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Complete Drill, Seat, and Window motors for trade | archiver | 2000 | 0 | 23-06-2002 22:16 |
| Complete Drill, Seat, and Window motors for trade | archiver | 2000 | 0 | 23-06-2002 22:16 |
| Blowing drill motors | archiver | 2000 | 6 | 23-06-2002 21:58 |
| "Motors and Drive train edition" of Fresh From the Forum | Ken Leung | CD Forum Support | 6 | 29-01-2002 12:32 |
| what about the drill motors? | Ken Leung | Motors | 2 | 26-06-2001 02:11 |
Linear Mode
