|
|
|
 "The audience will be making three sounds this year: oos, aahs, and oh my God, watch out!" - nate234 [more] |
 |
|
|||||||
|
||||||||
 |
| Thread Tools | Rate Thread | Display Modes |
|
|
|
| "The audience will be making three sounds this year: oos, aahs, and oh my God, watch out!" - nate234 [more] |
|
|
|||||||
|
||||||||
|
| Thread Tools | Rate Thread | Display Modes |
|
#1
|
|||
|
|||
|
Powering roboRIO with old PD Board
Our team wants to make an extra robot to show off to sponsors, but we don't have a complete new control system. We have an extra roboRIO, but we don't have extra of the PDP's or Voltage Regulator modules. Everything else is ready and wired; we only need to power the roboRIO. We powered the D-Link off the 12 volt port of the PDB with a 12 volt to 5 volt converter. The 5 volt and 24 volt ports are open. What do we have to do to get it to work? Do we need to order extra parts?
|
|
#2
23-02-2015, 14:52
|
|||||
|
|||||
|
Re: Powering roboRIO with old PD Board
The roboRIO wants raw battery voltage. Feed it from one of the small red/black Wago pairs protected by a 20-amp breaker. If you have any 10-amp breakers, you can use one of them instead.
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Linear Mode
