Can't configure WPI_MotorControlOpen.vi for "CAN Talon SRX" motor controller

[daveshike]

Originally Posted by jman4747

Did you by chance create a project with CRio target instead of a RoboRio target?

I didn't create the project. Do you know a way to check that we have the correct target?

[jman4747]

Originally Posted by daveshike

I didn't create the project. Do you know a way to check that we have the correct target?

Open project the explorer and see my attachments.

Edit: What Mark said too.

[ozrien]

Did you uninstall last year's LV before installing this years software? I always wondered what to expect if that was skipped.

"Uninstall Old Versions (Recommended)"...
http://wpilib.screenstepslive.com/s/...5-labview-only

[daveshike]

Thanks, everyone, for your help and advice. We'll continue working on this tomorrow. Hopefully we'll get it all sorted.

[Greg McKaskle]

The uninstall doesn't cause this. I have three year's of FRC on my same VM. The conflicts, if any, will be at the library and drivers, not the VIs or EXE.

Greg McKaskle

[daveshike]

Thanks, Mark, Josh, Omar, and Greg. The project was using the wrong API location. We found the needed VIs in the correct API location and used them.