Elevator Motion Profiling / PID Ramping

[JABot67]

You could try:

- Open loop speed control on the elevator, such as connecting the Y axis of an operator joystick directly to the elevator motor output

- Closed loop speed control on the elevator (instead of position control), such as using the Y axis of an operator joystick as the setpoint to a (rate/speed control) PID controller which controls the motor

- Limiting the maximum output of the PID controller using SetOutputRange (float mimimumOutput, float maximumOutput)

- Motion profiling

Honestly, the open loop control might be enough. It's basically closed loop control given that the operator can look at the position of the elevator from the driver station to determine if it's moving too fast. If you are trying to do this in autonomous, though, obviously you have to use some sort of closed loop control. Limiting the maximum output of the PID controller may be a good idea in that case.