06-03-2015, 07:55
|
 |
 |
Technical Director
AKA: Gus Michel II
 FRC #3946 (Tiger Robotics) Team Role: Mentor
|
|
Join Date: Jan 2014
Rookie Year: 2013
Location: Slidell, LA
Posts: 3,605
|
|
|
Re: Looking For T-Shirt Cannon Help.
Independent of the look and drive, a few safety and engineering tips:
- No PVC. Use plumbing rated for air pressure. When PVC fails under air pressure, the shrapnel is terrible.
- Relatively large pipes and hoses. Ours has 1-1/4" carrying air for 2 barrels, 1" after the split. The solenoid valve is 3/4", and if we were buying today, it'd be 1".
- Relatively low pressure - 40-50 psi.
- Large barrel - ours is 3" i.d. much easier to shoot with the low pressure/high flow.
- Short burst of air: I think we settled on 30 ms; at 50 ms we sent t-shirts over the press box.
- Offboard A/C compressor, large tank: I don't remember the numbers, but a 1 cfm compressor would have to run continuously unless you only shoot a couple of times a quarter.
- plan for rain. We wound up putting our electronics inside a rubbermaid tote.
__________________
If you can't find time to do it right, how are you going to find time to do it over?
If you don't pass it on, it never happened.
Robots are great, but inspiration is the reason we're here.
Friends don't let friends use master links.
Last edited by GeeTwo : 06-03-2015 at 07:57.
|
FRC is about what we collectively make of it. - Tristan Lall [more] 
Threaded Mode