|
|
|
 I've done enough preaching to the choir. Let's carry on changing the culture. - StevenB [more] |
 |
|
|||||||
|
||||||||
 |
| Thread Tools | Rate Thread | Display Modes |
|
|
|
| I've done enough preaching to the choir. Let's carry on changing the culture. - StevenB [more] |
|
|
|||||||
|
||||||||
|
| Thread Tools | Rate Thread | Display Modes |
|
#1
|
|||
|
|||
|
Problems With New Labview Update
Our team programs with two computers. We installed the newest Labview update on one of them. When we tried to deploy code on either of the two RoboRios we have a red light comm light on the RoboRio appeared. We then tried to deploy the same code with our other computer which didn't have the update installed and didn't have a problem. Is anyone else having similar issues to this?
|
|
#2
10-03-2015, 19:58
|
|||||
|
|||||
|
Re: Problems With New Labview Update
Is your roboRIO running image v23?
The older ones are probably using v22. Last edited by Mark McLeod : 10-03-2015 at 20:00.
|
|
#3
10-03-2015, 21:00
|
|||
|
|||
|
Re: Problems With New Labview Update
Both of the Roborios were running image V23. The only difference between them was one had firmware version 2.1.0f3 and the other had version 2.0.0b86. The one we did get woking is running version 2.0.0b86 because of the recent rule change that allows it.
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Linear Mode
