|
|
|
 If you have a problem with a team, go to that team and address it with them. Don't air your slanderous opinions here for all to see. - Andy Baker [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| If you have a problem with a team, go to that team and address it with them. Don't air your slanderous opinions here for all to see. - Andy Baker [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#2
11-03-2003, 12:23
|
|||
|
|||
|
I'm not sure what your problem is. I know i've seen it a lot with the trim being off on joysticks, but I'm not sure what your program might be doing, the only thing I could think of is that it doesn't set the output value for the pwm's to the motors to 127, but I'm not sure, hopefully someone will have something better for you, but worst come to worst I would think you should just have warmer motors.
Josh |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Running a motor for a set time in auton | Morgoth | Programming | 5 | 11-03-2003 13:59 |
| Can't figure out auton mode | TangoBravo1318 | Programming | 1 | 20-02-2003 10:06 |
| Looking for practice motors & extra tape drive parts? | archiver | 2000 | 1 | 23-06-2002 22:54 |
| "Motors and Drive train edition" of Fresh From the Forum | Ken Leung | CD Forum Support | 6 | 29-01-2002 12:32 |
| Drill Motors | TF8 | Motors | 19 | 12-12-2001 13:13 |
Threaded Mode