|
|
|
![]() |
|
|||||||
|
||||||||
![]() |
| Thread Tools |
Rating:
|
Display Modes |
|
#61
|
|||
|
|||
|
Re: VIAIR 250C-IG Compressor
You could probably use a pressure transducer and a known volume of airtanks to come up with a good estimation of flow rates for a compressor.
|
|
#62
|
||||
|
||||
|
Re: VIAIR 250C-IG Compressor
I think this method would be of somewhat limited usefulness.
|
|
#63
|
||||
|
||||
|
Re: VIAIR 250C-IG Compressor
The leader line actually looks quite useful. This year we had a few pneumatics leaks and didn't realize until someone pointed out the compressor has been running like nonstop. Eventually the hose off the compression had melted down a little and make the leak much bigger.
|
|
#64
|
||||
|
||||
|
Re: VIAIR 250C-IG Compressor
If anyone needs the CAD file for this compressor, I have taken the time to clean up the terrible STEP file VIAIR provides. Everything looks good except for the top component. The source STEP file is missing so many surfaces. I tried to get them to create a new STEP file, but did not have any luck. See attached.
|
![]() |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|