[FTC]: 80/20 and open builds mounting on tetrix

I used to think FIRST was about my learning experiences, but now that I'm out of high school and am a seasoned veteran of FIRST I've realized that this organization is about more than my own enjoyment, it's about the enjoyment of others. - Jeremiah Johnson [more]

		Chief Delphi > Other > FIRST Tech Challenge
[FTC]: 80/20 and open builds mounting on tetrix

Thread Tools

Rating:

Display Modes

28-04-2015, 22:01

robot

Registered User

no team

Join Date: Mar 2015

Location: USA

Posts: 10

robot is an unknown quantity at this point

Re: [FTC]: 80/20 and open builds mounting on tetrix

Quote:

Originally Posted by ehochstein

Have you tried Rev Extrusion from AndyMark?

http://www.andymark.com/product-p/am-2915.htm

I saw them at worlds in their booth. They're really lightweight, might have some good uses, but no, we have not attempted anything with these. We're working on 2 lifts right now and I think that's enough

p.s. the 80/20 we have is the smallest available, i think 20mm, and we use delrin sliders for 80/20 which may or may not work well

Last edited by robot : 29-04-2015 at 00:15.

« Previous Thread | Portal | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode	Rate This Thread:

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts vB code is On Smilies are On [IMG] code is On HTML code is Off

Forum Jump

All times are GMT -5. The time now is 17:41.

The Chief Delphi Forums are sponsored by Innovation First International, Inc.