|
|
|
A quote from the Southern California Regional Visitors guide:
"If you are having problems the FIRST thing to do is ask your neighbor for help" - ChrisH [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
|
A quote from the Southern California Regional Visitors guide:
"If you are having problems the FIRST thing to do is ask your neighbor for help" - ChrisH [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#1
|
||||
|
||||
Design Feedback?
I've recently been working on a custom winch gearbox for off season. Basically, it's a ~12.4:1 ratio, powered by one mini CIM. The output shaft is attached to the spool which reels in and lifts the fork mechanism (~10 lbs) + a six stack w/ RC (~60 lbs). I'm looking for some advice on design; the faceplates are 1/8" thick, two per each side with 1/4" standoffs. Here's a link to the solidworks files on GrabCad: https://grabcad.com/library/gearbox-updated-1
Any and all advice appreciated, thanks. |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Threaded Mode