Blown CIM? - Chief Delphi

If it walks like a duck, and talks like a duck could be a very clever animatronics display created by Disney Imagineers.... Sometimes it is just a duck. - IKE [more]

		Chief Delphi > Technical > Motors
Blown CIM?

Thread Tools

Rating:

Display Modes

29-05-2015, 14:48

FrankJ

Robot Mentor

FRC #2974 (WALT)

Team Role: Mentor

Join Date: Feb 2011

Rookie Year: 2009

Location: Marietta GA

Posts: 1,938

Re: Blown CIM?

Quote:

Originally Posted by Ether

Easier said than done, if you don't have a dynamometer.

Perhaps consistent or the same would have been better then "known". I was trying to think of simple tests without a lot of instrumentation.

I agree that ohming the motor has limited usefulness. It will tell you if you have open windings or a really bad commutator. Shorted winding look about the same as good windings to a typical ohm meter. Once again things to do with minimal tools.

__________________
If you don't know what you should hook up then you should read a data sheet

Last edited by FrankJ : 29-05-2015 at 15:02.

« Previous Thread | Portal | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode	Rate This Thread:

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts vB code is On Smilies are On [IMG] code is On HTML code is Off

Forum Jump

All times are GMT -5. The time now is 22:20.

The Chief Delphi Forums are sponsored by Innovation First International, Inc.