Talon SRX and Analog Encoders

[TBots]

Originally Posted by MaGiC_PiKaChU

1- we had tons of data cables, so we cut one side to connect each wire individually... you could also plug a small wire into each hole, but that would be harder

Cutting them would make it hard to plug them into the breakout board later. Just the same, we have had a lot of difficulty trying to find wires small enough to fit into the data cable's slots. Do you know what each hole does on the data cable?

Originally Posted by MaGiC_PiKaChU

2- No, your RoboRio has its own IP address, it changes if you connect via USB or ethernet. I don't remember the defaults, because we changed it to 10.33.60.2 as soon as we got it. You can find this address somewhere in the user's manual

The IP changes?? you mean it's not “roborio-XXXX.local”
where XXXX is the team number? It has an extension such as .2 or .6?