Quote:
Originally Posted by Thad House
No, it would not remember the setting after a reboot. Any new solenoid object always initializes to kOff. So it would print "it isn't or we don't know".
|
Alright, thanks a bunch.
Quote:
Originally Posted by GeeTwo
While the software wouldn't know, the hardware would probably still be in the same state. Double solenoids only change state when strobed, or when the little manual button is pressed - AND the supply port is pressurized. (Or they're taken apart,)
|
Yea, I was just wondering if the software would know. We always just had it reset itself to retracted in autonomous but it was a minor pain in the pits when nothing worked until we hit the extend button on the controller again.
Gracious Professionalism is being embarrassed at an event by an underperforming catstrophe of a robot, yet standing and applauding for every award because you realize that as hard as you worked that season, the other team must have worked even harder to get their achievements. - Taylor [more] 
Threaded Mode