2168 A3144 Hall effect sensor board

[Lialovefood]

Originally Posted by Travis Schuh

We used the ones from WCP (http://www.wcproducts.net/sensors) all over our robot last year and never had an issue about accuracy or repeatability. I know the chip has a spec somewhere, I will add them if I end up finding them.

I know this was from a while ago, but did you happen to find the spec sheet for this?

[Travis Schuh]

Originally Posted by Lialovefood

I know this was from a while ago, but did you happen to find the spec sheet for this?

I looked again and asked around, but didn't find it.

The best I can find is that the position that results in switching is most accurate when moving the magnet sideways in front of the sensor, rather than closer/further (see page 5 and 6 of the appilcation notes, found at http://www.melexis.com/Assets/Hall-A...de--3715.aspx).