|
|
|
 I think that in general people should worry more about what they are doing, and less about what others are doing. That goes for a lot more than FIRST. - pfreivald [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| I think that in general people should worry more about what they are doing, and less about what others are doing. That goes for a lot more than FIRST. - pfreivald [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#43
25-07-2015, 08:54
|
|||||
|
|||||
|
Re: Team 254 Presents: Deadlift Technical Binder 2015
How do you compensate for the big loss of strength in the HAZs of the 6061? How do you recommend other welded-chassis teams do it? Just blow up the thicknesses and section heights? I assume you don't do any detailed FEA or any post-weld heat treatment.
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Threaded Mode