In Need of Banebot Wheels

[sportzkrazzy]

Originally Posted by Karthik

We did not use the adhesive backed versions; we riveted the material on instead.

We tried the adhesive backed versions on manipulators in the past but even after giving it plenty of time to cure it did not want to stay on while under load. We tried using a couple of fastening methods as well but it would usually end up tearing out when under load. This was using strips that where 1 inch wide and with a thickness of 3/8ths of an inch. How wide were your strips and how did you fasten them? How often? Any issues with it tearing out?