Quote:
Originally Posted by ARI423
From what I can see, the two screws holding in the CIMs are accessible from the outside. One screw looks to be the top standoff screw, and there is a hole (in line with top and bottom standoffs, below CIM output shaft) to unscrew the other screw. Then it should be as simple as popping off the CIM gear and sliding it out of the enclosure. I could be wrong, but I imagine this was SerpentEagle's intent when designing it.
|
Quote:
Originally Posted by SerpentEagle
Would loctite solve this problem? But yeah I could probably just run the bolt all the way through to the CIM.
|
Wouldn't that ruin the accessibility of the CIM in the original design?
So Loctite would be the better choice.
They are "Human Dream and Inspiration Enablement Devices" but since that takes too long to say and explain I use the word "robot". - Foster [more] 
15-08-2015, 14:55
Threaded Mode