|
|
|
 Continue? You mean we can quit? Why didn't someone say so! - tsaksa [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools |
Rating: 
|
Display Modes |
|
|
|
| Continue? You mean we can quit? Why didn't someone say so! - tsaksa [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools |
Rating:
|
Display Modes |
|
#24
31-08-2015, 15:18
|
||||
|
||||
|
Re: Tapped Holes vs Bolt an Nut
Use 2D for this
 But when going through two walls of tubing with a bolt...avoid if possible. My preferred method is to put 45s on the ends of tubing so that you have a nice open face to work with. We used this on 314 often and I believe 973 does this as well. -Ronnie |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Threaded Mode