971 CNC Router

[Brian Selle]

Great job guys, very impressive. What kind of spindle/router did you use?

[Kstuck]

Very impressive!

Could you share what you use for hardware and software on the control side?

Thanks for sharing!

[thatprogrammer]

Have you had issues with belts stretching?

[Travis Schuh]

Originally Posted by Brian Selle

Great job guys, very impressive. What kind of spindle/router did you use?

We are using a 3HP, ADES70, 24,000 RPM Electric Spindle from here.

Originally Posted by Kstuck

Very impressive!

Could you share what you use for hardware and software on the control side?

Thanks for sharing!

We are running AMC motor controllers and brushed motors with USDigital encoders for hardware, the software is LinuxCNC.

Originally Posted by thatprogrammer

Have you had issues with belts stretching?

Not that we can tell, but it is still relatively new. The belts shouldn't stretch, but if they do we can re-tension them.

Originally Posted by MattRain

Any links to these pictures? Would like to see what we are talking about.

Our picture album originally referenced is here

[Scott Kozutsky]

Originally Posted by Travis Schuh

We are running AMC motor controllers and brushed motors with USDigital encoders for hardware, the software is LinuxCNC.

Do you mind elaborating on why you aren't using steppers? It's really awesome that you're going out of your way to develop your own machines and this is one of the most interesting aspects of it.

[AustinSchuh]

Originally Posted by Scott Kozutsky

Do you mind elaborating on why you aren't using steppers? It's really awesome that you're going out of your way to develop your own machines and this is one of the most interesting aspects of it.

Cause we can? We are able to hold some very tight tolerances and detect following errors the way we are currently doing it. This would be harder with steppers, and we would have less control over what is going on.

We are using mesanet boards with linuxcnc to interface with the AMC drives and encoders.