Encoders for 1/2" Output Shaft

Please don't act embarrassed if your designs didn't work out; join the club. You are learning and will get better every year. - Gary Dillard [more]

		Chief Delphi > FIRST > General Forum
Encoders for 1/2" Output Shaft

Thread Tools

Rate Thread

Display Modes

29-09-2015, 21:18

asid61

Registered User

AKA: Anand Rajamani

FRC #0115 (MVRT)

Team Role: Mechanical

Join Date: Jan 2014

Rookie Year: 2013

Location: Cupertino, CA

Posts: 2,222

Re: Encoders for 1/2" Output Shaft

I've been looking for one as well, perhaps for use on hex shaft.
So far I've found that the easiest thing to do is to put one earlier in the drivetrain, such as on the face of the CIMs, the gearbox shafts, or the ends of shafts.

EDIT: Why non-optical?

__________________
<Now accepting CAD requests and commissions>

Last edited by asid61 : 29-09-2015 at 21:40.

« Previous Thread | Portal | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode	Rate This Thread:

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts vB code is On Smilies are On [IMG] code is On HTML code is Off

Forum Jump

All times are GMT -5. The time now is 00:38.

The Chief Delphi Forums are sponsored by Innovation First International, Inc.