|
|
|
 You have the rest of your life to play video games. Time at an FRC tournament is precious. Use it wisely. - gblake [more] |
 |
|
|||||||
|
||||||||
 |
| Thread Tools | Rate Thread | Display Modes |
|
|
|
| You have the rest of your life to play video games. Time at an FRC tournament is precious. Use it wisely. - gblake [more] |
|
|
|||||||
|
||||||||
|
| Thread Tools | Rate Thread | Display Modes |
|
#1
|
||||
|
||||
|
[FTC]: Failed to start robot
The robot controller phone keep giving me the following message:
Robot Status: failed to start robot Unable to open Modern Robotics USB DC Motor Controller Unable to open USB device AL00YC5V - FT232R USB UART [AL00YC5V]: Unable to open USB device with serial number AL00YC5V I had to keep doing a "Setting->Restart Robot". If I am lucky, I will be able to succeed in 4 attempts. Sometimes, it helps if I power cycle the USB core interface. But then when trying to run the TeleOp opmode code, it went back to the above error. Lately, I am not able to get out of this. Please help. BTW, if I try to create a new Robot Configuration profile, no matter how many times I pressed the "Scan" button, it still said it found no hardware. If you try long enough, it may find one or two modules but very difficult to get it to find all the connected modules. Last edited by mikets : 14-10-2015 at 18:57. 
|
|
#2
14-10-2015, 20:55
|
||||
|
||||
|
Re: [FTC]: Failed to start robot
See this thread at the FTC forum: Update on USB Disconnect Issues (unable to detect USB modules during scan)
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Linear Mode
