|
|
|
 One wondered why they couldn't practice in the gym that day - because the robotics team had it reserved was the answer. "Oh, we have a robotics team?"
Sigh. This is a team with a low number. They've been around for at least a dozen years. There's still a lot more culture-changing to do. - GaryVoshol [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#4
03-11-2015, 23:03
|
||||
|
||||
|
Re: Help with gear sizes
Where did you get this picture from? If I had to take a guess the big gear on the drive shaft looks like an 84 tooth hex gear, assuming that those are 4" omni's. Also I'm pretty sure that there are 12 teeth on that pinion gear. I would suggest VexPro for gears, you can also buy the omni's there if you want.
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Threaded Mode