[FTC]: Rev Robotics Linear Extender Kit Preguntas

[MattRain]

Originally Posted by pilum40

also how would I power this set up to extend and retract? I've got some Vex linear motion kits but am not sure if they're legal. I could attach the rack onto the extrusion I'm thinking and run it through the system. Not sure if the Vex motor will be strong enoiugh. Again...any help would be appreciated. Thanks

We machined a few parts that allow us to have v-grooved bearings on the outside of our slides. The wires are set up in such a way that all of the slides move at once, when the bottom wire is winched into the robot. I haven't seen any videos/manuals from RevRobotics yet, but I imagine that Greg and the team are busy getting ready for the FRC season.

The way that we designed our lift, required us to combine two 17in sections together for all of the middle slides, (We have 4 sliding sections). On the tops of these combined slides, we also tapped a plate into place, that holds the middle, double slider in, as we couldn't figure out how to keep them in place, so we just let them free slide in place.